Skip to main content Skip to search Skip to main navigation
DPA ST4006A

Directional pattern: Omnidirectional

Operating principle: Pressure

Capsule type: Pre-polarised condenser

Frequency response: 10 Hz - 20 kHz

Effective frequency range +/-2 dB: 10 Hz - 20 kHz

Nominal sensitivity +/-2 dB at 250 Hz: 40 mV / Pa; -28 dB re. 1 V / Pa

Equivalent noise level, A-weighted: Typ. 15 dB (A) re. 20 uPa (max. 17 dB (A))

Equivalent noise level, ITU-R BS.468-4: Typ. 27 dB (max. 29 dB)

Distortion, THD <1%: 136 dB SPL RMS, 139 dB SPL peak

Dynamic range: Typ. 124 dB

Max. Sound pressure, THD 10%: 146 dB sound pressure peak

Switchable attenuator, filter etc.: 0 dB / -20 dB

Nominal output impedance: 200 Ω

Minimum load impedance: 2 kΩ

Cable drive capacity: 100 m (328 ft)

Output balance principle: Impedance equalisation with Active Drive

Common mode rejection ratio (CMRR): > 60 dB

Power supply (for full power): P48 (phantom power)

Current consumption: 2.8 mA

Connection: XLR-3M. Pin 1: Shield, Pin 2: Signal + phase, Pin 3: - phase

Colour: Matt black

Weight: 163 g

Microphone diameter: 16 - 19 mm (0.6 - 0.75 in)

Capsule diameter: 16 mm

Microphone length: 170 mm (6.7 in)

Maximum output voltage, RMS: 8.0 V.

Polarity: + V on pin 2 for positive sound pressure

Temperature range: -40 ° C to 45 ° C (-40 ° F to 113 ° F)

Relative humidity (RH): Up to 90%

Matching tolerance (frequency response and sensitivity): ± 0.5 dB

Phase deviation for kit: <5°

The d:dicate™ 4006A omnidirectional microphone is a flexible solution. Sound engineers, producers and musicians appreciate its clear, natural and precise sound reproduction. It is the ideal microphone for AB stereo recordings of symphonic concerts. It is also ideal for direct miking of all types of instruments and as a microphone for outdoor interviews.


For reference stereo recordings, there is no better choice than the d:dicate™ 4006A omnidirectional microphone. These omnidirectional condenser microphones are linear and deliver faithful recordings. They are manually matched and offer the most faithful recording of stereo sound available.

Properties

Characteristic: Ball
Directional microphone: No
Incl. Clamp: Yes
Low cut: No
Pad: No
Stereo pair: Yes
Type of construction: Capacitor
DPA Microphones

Contact:

DPA Microphones A/S
Kokkedal Industripark 101
DK-2980 Kokkedal

E-mail: info-de@dpamicrophones.com
Web: https://www.dpamicrophones.com/de/

0 of 0 reviews

Average rating of 0 out of 5 stars

Leave a review!

Share your experiences with other customers.


Ähnliche Artikel

Schoeps V4 U SGV SET
Manufacturer:
The V4 U is the studio vocal microphone from SCHOEPS.It combines the outstanding technical features typical of SCHOEPS with a timeless, classic design.The appearance of the V4 U is based on the SCHOEPS CM 51/3 microphone from 1951. However, the V4 U is a modern cardioid microphone: the capsule, electronics and mechanics are the result of an elaborate new development.
€2,599.00*
Lewitt LCT 140 AIR stereo pair
Manufacturer:
The LCT 140 AIR stereo pair consists of two perfectly matched small diaphragm condenser microphones with switchable sound characteristics for acoustic instruments.Two switchable sound characteristics:AIR delivers an open character with a pleasantly emphasised high-end. The right choice when you need a great sound without spending time on post-production.FLAT offers a linear frequency response for accurate reproduction of drums, strings, acoustic guitars and choirs. Perfect if you're into realistic soundscapes.Perfect stereo image through precise matching:LEWITT uses one of the most precise matching processes in the industry. The difference between the two microphones of a stereo pair is inaudible. How does it work?The frequency response and sensitivity of each microphone is analysed.A measurement system controls the polarisation voltage of the capsule to adjust the sensitivity so that it is the same for all LCT 140 AIRs.An algorithm then compares the measured frequency response of each individual microphone and finds the perfect pairs.Equipped for all recording situations:Transients are the DNA of an instrument's sound. To preserve the natural musicality of your instruments, the LCT 140 AIR delivers outstanding impulse fidelity. To be prepared for all eventualities, the LCT 140 AIR has a low-cut and a PAD switch. This means you won't break a sweat with extremely loud instruments, nor will you have to deal with low-frequency noise if you don't want to.The LCT 140 AIR is ideal for:Acoustic guitarDrumsStringsChoirsPianoUkuleleDurable and lightweight aluminium housing:Thanks to its CNC-milled aluminium housing, the LCT 140 AIR is extremely durable yet lightweight. Positioning and alignment in heavy-duty use is child's play.
€285.00*
SE Electronics sE 8 Stereo Set
Manufacturer:
The new sE8 is a high-quality small diaphragm microphone with outstanding sound characteristics. The elaborately manufactured electrode enables a very balanced and particularly natural transmission of instruments of all kinds. This also allows the intensive use of EQs or filters without making the recording unpleasant. With the highest dynamic range and the highest overload resistance in its class as well as the practical, switchable attenuation and high-pass filters, the sE8 offers unbeatable flexibility for every application in the studio and on stage.
€389.00*
Schoeps mono set CMC 1 L and MK 21
Manufacturer:
€1,679.00*
Schoeps Desert Island Set with MK 4
Manufacturer:
SCHOEPS now also offers the best-selling modular microphone series Colette in a handy and robust Peli Case as a pair at a set price.
€3,098.00*