Power

The PG-1 Type F is a professional power conditioner with extensive features. It contains a bank of eight switchable, filtered and overvoltage-protected outputs. Two filtered outputs and a connection for a 3-pin XLR lamp are located on the front, with a further 6 outputs, an earthing terminal and the mains connection on the rear. The display and other LEDs on the front provide constant visual feedback on the input voltage as well as the status of earthing, polarity, filtering of interference signals, AC voltage and overvoltage protection. The outputs are individually optimised for digital, analogue or particularly "current-hungry" devices. A two-stage system for sequenced start-up and shutdown has also been implemented. To minimise unhealthy pop noises when switching speakers and amplifiers on or off, the "High Current" outputs are slightly delayed and are switched on and off last in the system.

With the PG-2 Type F, Black Lion Audio presents a high-quality power conditioner in rack format with a multitude of practical functions. The PG-99 filter technology enables almost 100 per cent noise filtering thanks to selected Panasonic and Wima condensers. This puts the PG-2 Type F on a par with significantly more expensive power conditioners in rack format. The powerful overvoltage protection with an absorption capacity of 2775 joules reliably protects the studio hardware from damaging current peaks. Up to 14 devices can be supplied with power. The built-in time delay prevents unwanted "crackling noises" to protect loudspeakers and amplifiers. Equipped with a status display and warning functions, the PG-2 Type F is the professional power distribution system that studio operators can rely on.

The IEC lock mechanism prevents the IEC plug from being pulled out accidentally. Thanks to this innovation, the plug remains securely in the installation socket at all times - even in the event of vibrations or other disturbances in the event technology sector. This guarantees a reliable and stable connection.

The DPS-2 is an exceptional linear power supply unit which, in addition to its outstanding technical data, impresses with itsFeatures and practical functions. For example, the compact device hastwo outputs, each with different filtering. The housing design and front panel of the DPS-2is based on the ADI-2 series and accommodates RME's innovative circuit design in only half the rack width.The Linear output is a classic DC output, but is equipped with multi-stage passive and active filters, including a 30,000 kHz filterincluding a 30,000 F capacitor bank, a ferrite choke and an active output filter with hybrid voltage regulatorHybrid voltage regulator.The second output is based on the filter technology developed by RME. For this purpose, the signal from thepre-filtered linear output is additionally processed with highly efficient active filters to produce an exceptionally cleanDC output signal with only a few micro-volts of interference. In addition, the output featuresSensor technology that measures and regulates the output voltage directly at the DC plug of the special DC cable suppliedregulated. The result is an extremely low output impedance and load regulation, which ensures a clean output voltage ofOutput voltage of +12.0 V at 2.5 A and almost completely eliminates load-dependent voltage drops.Thanks to the additional use of a two-stage HF mains filter and a DC mains filter on the AC side, theDPS-2 enables optimum performance without interference noise. The 60 VA audio toroidal transformer also contributes to this with itsadditional insulation winding and the magnetic shielding tape guarantees absolutely hum- and noise-free operation in any situationin any situation.The ground lift switch can be used to disconnect the earth of the DC output from the earthing contact if required, for example to eliminate ground loops. This does not affect safety, as the earthing contact of the mains cable is still firmly connected to the housing and the earthing terminal. In addition, the DPS-2 has an earthing screw (GND screw terminal) to earth other devices or to use an earthing other than Schuko for the audio power supply. For a quick overview of the most important operating statuses and faults (existing input and output voltage, overload, undervoltage, short circuit), the DPS-2 has a short-circuit indicator,Short circuit), the DPS-2 has two multi-coloured front LEDs. An AutoDark mode can be activated via a recessed push switch on the front of the device, in whichmode, in which the LEDs only light up when the DPS-2 is switched on and when errors occur.